Transistor tester
Automatic detection of NPN and PNP bipolartransistors.N-channel and P-chmnnel MOSFETs,
JFETs diodes(including double Diodes)N.and P-IGBTS, resisiors, Inductors, capacitors,
thyristors,triac and battery (0 .1-4.50V) Automatie detection of zener diode (0.01-20v).
Self test with automatic calibration
IR decoder
Support Hitachi IR coding
IR waveform display
Other
Measurement results using TFT graphic display(160x128)
Auto Power Off(Timeout Settable)
Built-in rechargeable Li-ion Battery
Li-ion Battery voltage detection- 160x128 TFT display
Power on
In the power off state, short press the multifunction key,
the tester is turnedon and automatically measured.
IR decoder
After the component test is completed, point the infrared remote control at the "IR" test hole of the tester,
press the remote control button, the tester will display the user code and data code after successful decoding,
and display the corresponding infrared waveform.
If the decoding fails or the decoding fails, the user code and data code cannot be displayed.
At this time, if you are in the tester interface, you cannot enter the infrared decoding interface.
If you are in the infrared decoding interface, the last successful decoding information will still be displayed.
Detect Zener Diode
When the device is turned off or the test is completed, put the Zener diode into the Zener diode test area,
press the locking handle, and briefly press the multi-function button.
Automatic calibration
Short-circuit three test sockets, short press the multi-function button, and the tester will automatically calibrate.
During the calibration process, there is no need to perform other operations except to disconnect the short
wire according to the prompts.
Shutdown
Automatic shutdown after timeout
When the component test is completed or the infrared decoding is completed, and the automatic
shutdown time is reached, the tester will automatically shut down (overtime 30 seconds)
Standby power consumption is 0 uA after shutdown.

Battery voltage measurement

Before each component measurement, the built-in lithium battery voltage will be detected and displayed.

When the battery voltage is less than 3.1V, it will be forced to shut down. Please charge it at this time